11/14/2022 0 Comments Fisher price monkey bouncer assembly![]() Position the left and right base wires, as shown.Place the base tube on a flat surface.Tighten or loosen all screws with a Phillips screwdriver. IMPORTANT! Please remove all parts from the package and identify them before assembly. To replace the pad, refer to Assembly steps 6 – 10.Remove the bottom pocket of the pad from the footrest.Unfasten the straps on the back of the seat.Rinse clean with water to remove residue. The frame, toy bar, and toys may be wiped clean using a mild cleaning solution and damp cloth.Tumble dry separately on low heat and remove promptly. Wash them separately in cold water on the gentle cycle. The pad and infant support are machines washable.Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Check your local authority for recycling advice and facilities. This symbol indicates that this product shall not be treated as household waste. Protect the environment by not disposing of this product or any batteries with household waste. If removable, rechargeable batteries are used, they are only to be charged under adult supervision.Remove rechargeable batteries from the product before charging.Do not charge non-rechargeable batteries.Use only batteries of the same or equivalent type as recommended.Never short-circuit the battery terminals.The batteries inside may explode or leak. Always remove exhausted batteries from the product. Remove batteries during long periods of non-use.Insert batteries as indicated inside the battery compartment.Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc), or rechargeable.In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. Slide the power switch off and then back on. If this product begins to operate erratically, you may need to reset the electronics.Fasten the pad straps on the back of the pad around the soothing unit.Pull and fit the pad seat bottom pocket around the soothing unit and footrest.Replace the battery compartment door and tighten the screw.Insert three C (LR14) alkaline batteries into the battery compartment.Loosen the screw in the battery compartment door.Remove the pad bottom pocket from the footrest C.Pull to remove the pad from around the tabs and the soothing unit B.Unfasten the pad straps on the back of the pad around the soothing unit A.Remove and properly dispose of the batteries and replace them with three new C (LR14) alkaline batteries. IMPORTANT! Low battery power causes this product to operate erratically: no vibrations and the product may not turn off. #Fisher price monkey bouncer assembly free#Pull the anchored end of the restraint belt to shorten the free end of the restraint belt B. Enlarge the loop by pulling on the end of the loop toward the buckle. Feed the free end of the restraint belt up through the buckle to form a loop A.Pull the free end of the restraint belt B. Feed the anchored end of the restraint belt up through the buckle to form a loop A.Do not use accessories or replacement parts other than those approved by the manufacturer. Do not use this infant bouncer if it is damaged or broken. IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts, or sharp edges. This product is not intended to replace a crib or bassinet for prolonged periods of sleep. STOP using bouncer when baby starts trying to sit up or has reached 20 lb (9 kg), whichever comes first.Adjust to fit snugly, even if baby falls asleep. NEVER use it on a bed, sofa, cushion, or another soft surface.Suffocation Hazard: Babies have suffocated when bouncers tipped over on soft surfaces. NEVER lift or carry a baby in the bouncer.Adjust to fit snugly, even if baby falls asleep. WARNING Fall Hazard: Babies have suffered skull fractures falling while in and from bouncers. Product features and decorations may vary from photographs.Use from birth until baby starts trying to sit up or has reached 20 lb (9 kg), whichever comes first.Requires three C (LR14) alkaline batteries (not included) for soothing unit operation.Tools needed for assembly: Phillips screwdriver (not included).Īssembly instructions on the backside of this sheet. IMPORTANT! Read all instructions before use of the infant bouncer seat. Press the volume buttons to adjust the volume level.Press the music or sound effects button to play sounds.Press the vibration button to turn vibrations on. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |